Signal Shapes for Gassiplex Setup
From Sequencer the signals are like this:
1) T/H It is from + 5V to zero.
2) CLK same as above
So these two should go to one section of TTL-NIM with the
switch on OUT-BAR position.
Then only these signals will be
from 0 to -700mv.
3) From Sequencer
Clear signal is from Zero to + 5V.
So it should go to other TTL -NIM section with OUT switch
in OUT position only.
Then the signal output will be from Zero to -700mV.
Finally at the input of The Translator board which we made
you should get
all NIM fast signals with zero to -700mv.