Next: Run Control: disconnecting Up: Troubleshooting

Run Control: MiniDAQ Crash/Slow Controls OK

  1. If Slow Controls is running, pull down the Slow Controls (SC) panel from the Run Control tool bar and click ``Abort''.
  2. Re-boot MiniDAQ.
  3. When MiniDAQ is ready, the Run Control console should show the DAQ state as ``connected''.
  4. Move the Slow Controls and DAQ panels off to the side.
  5. Go through the Init, Configure, Getset and Go steps through Run Control.

Written: November 27, 1996 by Eugene Yee and Nathan Stone
Modified: January 27, 1997 by Eugene Yee
Last modified: July 8, 1997 by R.Bossingham

Page maintenance:

Roy Bossingham, LBNL
RRBossingham@lbl.gov