end of run work

From: Geary Eppley (eppley_at_physics.rice.edu)
Date: Sat May 10 2003 - 08:40:48 EDT

• Next message: Lijuan Ruan: "[Fwd: occupancy plot]"
• Previous message: Geary Eppley: "freon gas bottle change"

Hi Bill,

The TOF system will need access the south platform at the end of the
run to measure noise rates. We also may need to make some measurements
where the pigtails come out on the east pole tip. This can all
be done in about eight hours after which we can shut off the
gas flow. Immediately after the east pole tip is removed, we will want to
remove the TOFr tray and plan to set up a small work area in one corner of
the clean room.

Geary

• Next message: Lijuan Ruan: "[Fwd: occupancy plot]"
• Previous message: Geary Eppley: "freon gas bottle change"

This archive was generated by hypermail 2.1.4 : Thu Jul 24 2003 - 00:39:41 EDT