Next: Doing a Pedestal Run
Up: MiniDAQ instructions
Previous: Checking Operating Conditions
Setting Up Tape Writing
-
Load an Exabyte tape into the TTi 8210 near the MiniDAQ crate.
Be sure to disable write-protection; trying to write to a protected tape
will cause problems.
-
Select the MiniDAQ desktop on deneb's console; go to the
Table_Browser.
Click Taper parameters and verify that taper0 is set to ``1.''
(If not, set it; click the right mouse button; select close
from the menu; click on Yes in the ``Save?''dialog box that pops up.)
-
Go to the tapeunit.dl; click Online.
Written: October 3, 1996 by R.Bossingham
Last modified: April 21, 1997 by R.Bossingham
Page maintenance:
Roy Bossingham, LBNL
RRBossingham@lbl.gov